How to troubleshoot daily swing brake failures?

For many current occasions where people are entering and exiting, the pedestrian passage gate is an important equipment for the management and registration of personnel entry and exit. And here, swing gates are more common among pedestrian gates. However, because of the continuous use every day, there is almost no stop. Therefore, there will be some faults that will cause traffic problems. How do we troubleshoot and deal with the daily faults of the swing gate today? Let's take a look at the introduction of the staff of Zhichuanghong Technology.

1. After swiping the card, the swing door does not open, and there is no response, or it does not open automatically after the power is off. Check from the beginning to see if the open signal line has fallen, and check whether the open signal indicator on the main board has been opened. Signal.

2. After swiping the card, the gate is opened, but the gate is not closed. In this case, the anti-pinch infrared in the middle is usually not properly aligned. Before fixing the case, it is necessary to make sure that the infrared pairing is good, so that the door can be opened and closed normally. If the infrared is not properly aligned, an alarm will be displayed after power-on. After swiping the card, please follow the direction arrow.

3. After swiping the card, one of the property swing gates will open, and the other will not. Check from the beginning whether the sync cable is connected properly. After connecting, make sure that the motherboard that you can't turn on has received a signal to turn on. If not, check whether the wiring is dropped from the beginning and whether the plug on the motherboard is properly inserted.

4. The property swing gate has the function of automatically turning on after the power is off. If it does not turn on after the power is off, the cause is that the voltage of the backup battery (battery) inside is not enough. You can use a multimeter to measure whether the voltage is above 10V.

5. The job status indicated by the direction is respectively, the green arrow points to the left, points to the right, or the red cross. If the direction indication does not respond, or the indicated direction is incorrect. You can switch to another test, and try it with a good one. Check the wiring from the beginning.